DPF-AN2TH
Analog-digital temperature and humidity controller sensor with LED signaling, relay alarm, for indoor use.
- Manufacturer: DPF Sensors
- Category: SENSORS, Humidity Sensors, Temperature sensors, Temperature sensors for air conditioning
Analog-digital temperature and humidity controller sensor with LED signaling, relay alarm, for indoor use.
Output signal 0-10 Vdc + 8 amp NA relay
Ranges: Temperature: 0…+50ºC / humidity: 0….100%
Power supply: 110-230 Vac
Properties
Other products
90 mm flange, servo, 12 mm h7 shaft | Up to 2²⁴ steps in 4096 revolutions | Gray, binary or BCD | Parallel NPN/push-pull or SSI RS422 | Power supply 5 ±5 %, 8–24 or 18–28 V | IP64 shaft (IP65 sealed) | Optional latch, zero LED, multiplexer
Through-shaft Ø16–30 H7 | Ø90 mm, centered Ø80 h7 | 1–36000 imp/rev | NPN, PNP, push-pull, driver, TTL | 5–30 V | IP65 shaft | 100 kHz (500 kHz optional)
Linear Range 0-5mm | Sensitivity 4mV/µm | AISI 4140 Stainless Steel | Probe -30 to 180°C | Driver -20 to 80°C | M16 x 1 Thread | Frequency DC-10kHz | Linearity <1% | PEEK Tip | PTFE Cable
Brida cuadrada 44×44 mm, eje Ø6 h7 | 8192 pasos/vuelta (13 bits) | SSI (RS422), binario natural | Alimentación 5 V, 5–30 o 10–30 V | IP66 eje (IP53 con bajo par) | Frecuencia máx. 500 kHz | Impactos 100 G (6 ms)
Salida en corriente 0…20 mA o 4…20 mA | Ø 55 mm | Eje Ø 6 mm | 24 ±6 V DC | IP 65 | 90° o 345°
Three-phase network analyzer with indication, RS485, Input 3 x ..90Amp directly (through hole – 3 x 550VAC)
CAN SAE J1939 | Ø 36 mm | 16 bits por vuelta | Eje Ø 6 mm, Ø 10 mm o hueco Ø 6 mm | 12/24 VDC (8 … 32 VDC) | IP67 / IP69K | Rango de medida: 44 vueltas (15840°)
Threaded flange 18×1 | Housing Ø40 mm, shaft Ø6 h7 (Ø8 optional) | 10–2500 rpm | NPN, push-pull, line driver | 5 V ±5 % or 12–24 V | IP52 shaft (IP65 with retainer, option Q) | Max. frequency 180 kHz
CO2, humidity and temperature sensor, for OUTDOORS, with ModBus RS485 communication