DPF-CO2-ANCO2L
Indoor CO2 sensor, range up to 4000 ppm, analog output and relay alarm
- Manufacturer: DPF Sensors
- Category: SENSORS, Gas Sensors
Indoor CO2 sensor, range up to 4000 ppm, analog output and relay alarm
Output signal 0-10 Vdc / open contact alarm
Power supply 110-230 Vac
NDIR sensor
Properties
Other products
Housing Ø50 mm | Shaft Ø 4 mm / 5 / 8 mm Stainless Steel | Operating Temp. 0 – +70 °C | Resolution 2 to 8 bits (4 to 256 positions) | Max. Load 2 Kg | Max. Frequency 50 kHz | Weight 220 g | Vibration 12 G (10 – 2000 Hz) | Impacts 50 G x 11 ms | Power Supply 5V | Protection IP65 | Life 1.5×10^9 Rev
Inductive PCM Transmission | 60,000 N·m | 8,000 RPM | PCD Flange 369.0 mm | Inertia 1.6378 kg·m²
Top Outlet, Intrinsically Safe ATEX/IECEx | 4-20mA DC Output | RMS Acceleration Measurement | Configurable Range | Frequency 2Hz-1kHz | Power Supply 12-32V DC | Temperature -55 to 90°C | IP67 Protection | Stainless Steel | Mil-C-5015 Connector
Top Input | Sensitivity 100mV/g | Frequency 2Hz-10kHz | Isolated AC Output | Dynamic Range ±80g | IEPE Power Supply | Temperature -55 to 140°C | IP67 Protection | Stainless Steel | 2-pin Connector Mil-C-5015
Resolution up to 65536 steps/revolution (16-bit) | Shock resistance 50 G (11 ms) | SSI interface with preset · Gray or Binary | Sine/Cosine output 1024 ppr or RS422 up to 16384 ppr | Power supply 10–30 V · max. consumption 200 mA | B10 flanged housing | Ø11 h7 stainless steel spindle | Spindle-side protection IP64 (IP66 sealed) | Max. continuous speed 6000 rpm (3000 rpm sealed) | Operating temperature -20…+85 °C
Slot Sensor | 22mm Pitch | 20mm Stroke | 4-20mA, ±10V Outputs | IP66 Hermetic | Infinite Resolution | High Repeatability
Aluminum housing Ø59 mm with integrated flexible coupling | PROFIBUS-DP Class 2 interface | Max. transmission speed 12 MBaud | Max. resolution 16 bits/revolution · 30 bits in 16384 revolutions | Binary output code | Power supply 10–30 V DC, max. consumption 2.5 W | Hollow shaft F7: Ø15 mm standard (Ø8, Ø10, Ø12 or others on request) | Coupling compensation: axial ±0.1 mm, radial ±0.2 mm, angular ±1° | IP64 protection on shaft (IP66 sealed) | Operating temperature -40 … +85 °C
Linear Range 0-12mm | Sensitivity 1.0mV/µm | AISI 4140 Stainless Steel | Probe -30 to 180°C | Driver -20 to 80°C | M30 x 1.5 Thread | Frequency DC-10kHz | Linearity <1% | PEEK Tip | PTFE Cable