OFI-RTD-IN-minidis
Wall temperature sensor with Pt100 sensor, built-in Data Logger and indicator.
Pt100 probe inside, measuring ambient temperature.
Output: 4/20mA (Passive) + built-in minidisplay
Power supply: 24VDC per loop (6.. 30V)
Properties
Other products
It measures up to ~100 m over natural surfaces and up to 150 m with a reflector, with a typical accuracy of ±3 mm @2σ and a frequency of up to 100 Hz. It is geared towards position and level applications where ±1 mm accuracy is not required.
Ø72 mm | Hollow shaft Ø10 to Ø20 mm | Max. axial compensation ±3 mm | Max. radial compensation ±0.05 mm | Max. angular compensation ±2° | Max. frequency 100 kHz (300 kHz optional) | 1 to 25000 imp/v | Anodized aluminum base and Valox 420 cover | Weight 470 g | IP64 on the shaft side (IP66 sealed)
Resolution up to 65536 steps/revolution (16-bit) | Up to 4096 revolutions (12-bit) | SSI interface with preset · Gray or Binary | Sine/Cosine output 1024 ppr or RS422 up to 16384 ppr | Power supply 10–30 V · max. consumption 200 mA | Housing Ø65 mm | Spindle Ø10 h7 stainless steel | Spindle side protection IP65 (IP66 sealed) | Max. continuous speed 6000 rpm (3000 rpm sealed) | Operating temperature -20…+85 °C
Square flange 44×44 mm | Front centering Ø20 h7 | Resolution from 8 to 2048 pulses/rotation | Bidirectional output with zero (BZ) | Up to 12000 rpm continuous with low torque bearings (B) | Ø6 h7 stainless steel shaft | IP66 on the shaft side (standard) | Electronic drivers: 26LS31, ET7272 and NPN | Shock resistance: 100 G (6 ms) | Power supply: 5 V, 8÷24 V, 18÷28 V, 10÷30 V or 5÷30 V
Wirelessly configurable RTD to 4/20mA converter in IP65 waterproof case, without probe, built-in Data Logger + display.
4/20mA cable converter for 1 load cell, Built-in multiplexed 4/20mA output signal (allows individual control of each cell)
General Purpose | Stainless Steel | TNC Connector | Sensitivity 100mV/g | Frequency 2Hz-13kHz | Non-Insulated Base | IP65 Protection | Range ±80g | Weight 52g | Temp. -25 to 120°C
Built-in elastic coupling | Aluminum housing Ø59 mm | Maximum resolution of 16 bits per revolution | Synchronous serial interface SSI (RS422) | Gray and Binary output codes | Preset (S1) or preset pushbutton (S4) options | 10–30 V DC power supply | Hollow shaft F7: Ø15 mm standard (Ø8, Ø10, Ø12 or others on request) | IP64 protection on shaft (IP66 sealed) | Working temperature -40…+85 °C (with cable: -5…+70 °C)
Graphite sensor with built-in NTC10K, 3m cable, K=1 cm⁻¹Range from 2MicroSiemens to 2,000 milliSiemens,