SI308T CONDUCTIVITY SENSOR

For ultrapure water Cell content K=0.01cm-1 (0.2 to 20µS) Thread 1″ BSP, PVC body material, PT-100 for temperature measurement

Manufacturer: B&C Electronics
Category: Water quality, SENSORS, Conductivity Sensors

B&C Electronics' SI308T Electrical Conductivity (EC) Sensor is a conductivity cell designed to measure electrical conductivity in ultrapure water.

This type of sensor is widely used to measure ultrapure water in industries such as food, chemical, pharmaceutical, laboratories.

Its operating principle is based on measuring the capacity of the liquid to conduct an electric current. The sensor has two electrodes that come into contact with the liquid to be measured and an alternating signal is applied through the electrodes to avoid polarization. The electric current that flows between the electrodes depends on the concentration of ions in the liquid. The higher the concentration of ions, the higher the conductivity. It also has a temperature probe for greater precision in the calculation.

Properties

Technical Features B&C Electronics Conductivity Sensor
Cell constant	K=0.01 cm-1 (0.2 to 20µS)
Body material	PVC
2 electrodes	316S Stainless Steel
Thread	1” BSP
Maximum working temperature	50ºC
Temperature compensation	PT100 sensor on the probe
Maximum working pressure	3Bar

Other products

Weathervane-420-M12

Wind direction sensor for industrial use, with 4-20 mA output signal

Meteorology – Climatology, SENSORS, Wind

Incremental Encoder for Motors I/59ZP

Very robust Ø59 mm | Through-hole shaft Ø6–15 mm | Anti-rotation pin Ø5 mm | Max. frequency 100 kHz (300 kHz optional) | 1 to 3600 imp/v | Anodized aluminum base and Valox 420 cover | Weight 300 g | IP64 on the shaft side (IP65 sealed) | NPN, PNP, push-pull, line driver, TTL and 1 Vpp sinusoidal outputs | IP65 radial cable or IP67 connector

Encoder, Incremental Encoder, Incremental Encoder for Motors, SENSORS

Membrane

CNM SERIES

SENSORS, Level Sensors, Level sensors for solids

GSA System Gear Shift Analysis | Forces and Travel | Dynamic Test

Change Analysis | ±200 N (Optional 500 N) | ±125 mm (Optional 150 mm) | 400 kHz Sampling | 8 Channels

Accessories, Torque sensor

Intrinsically Safe Velocity Transducer Monitran MTN/2285

Top Outlet | Intrinsically Safe ATEX/IECEx | 4-20mA DC Output | RMS Speed Measurement | Configurable Range | Frequency 2Hz-1kHz | Power Supply 12-32V DC | Temperature -55 to 90°C | IP67 Protection | Stainless Steel | M12 Connector

Accelerometers and Vibration Sensors, Amplified, ATEX, SENSORS

High Resolution Incremental Encoder I/100D

Housing Ø90 mm | Square flange 100 mm | Shaft Ø10 g6 stainless steel | 18,000 to 900,000 pulses/revolution | Accuracy ±5 arc seconds | Max. frequency 160–2200 kHz | Power supply 5 V ±5 % | Driver outputs 26LS31 and 1 Vpp sinusoidal | IP54 shaft side (IP65 output) | 500 rpm continuous

Encoder, Incremental Encoder, High Resolution Incremental Encoder, SENSORS

Robust Incremental Encoder I/63

Metal housing Ø63 mm | Square mounting flange | Ø9.52 h7 stainless steel shaft | 1 to 25,000 pulses/revolution | Max. frequency 100 kHz | Power supply 5–30 V | 15 output electronics | IP65 shaft side (IP66 sealed) | 6,000 rpm continuous | Weight 570 g

Encoder, Incremental Encoder, Robust Incremental Encoder, SENSORS

A/759UMA Multi-Turn Absolute Encoder

Resolution up to 65536 steps/revolution (16-bit) | Up to 4096 revolutions (12-bit) | SSI interface with preset · Gray or Binary | Sine/Cosine output 1024 ppr or RS422 up to 16384 ppr | Power supply 10–30 V · max. consumption 200 mA | Hollow spindle H7: Ø6, Ø8, Ø10, Ø12 or Ø15 mm | Flexible coupling | Shaft-side protection IP64 (IP66 sealed) | Max. continuous speed 6000 rpm (3000 rpm sealed) | Operating temperature -20…+85 °C

Encoder, Absolute Encoder, Multi-turn Absolute Encoder, SENSORS

DPF-AN2TH

Analog-digital temperature and humidity controller sensor with LED signaling, relay alarm, for indoor use.

SENSORS, Humidity Sensors, Temperature sensors, Temperature sensors for air conditioning

Special Incremental Encoder I/58SX

Special Series | Stainless Steel Cover | Ø6 h7 Stainless Steel Shaft | Marine and Chemical Environments | Resolution 1 to 25000 imp/v | Frequency 100 kHz (300 kHz optional) | Axial or Radial Output | Ø50 h7 Centering | IP64 on the shaft side | Weight 520 g

Encoder, Incremental Encoder, Special Incremental Encoder, SENSORS