SI3013 CONDUCTIVITY SENSOR
Cell content K=1cm-1 (2 to 2,000µS) Thread 1″ BSP, body material polypropylene
- Manufacturer: B&C Electronics
- Category: Water quality, SENSORS, Conductivity Sensors
The B&C Electronics SI3013 Electrical Conductivity (CE) Sensor is a conductivity cell designed to measure the electrical conductivity of liquids.
This type of sensor is widely used in industries such as food, chemical, pharmaceutical and water treatment.
Its operating principle is based on measuring the capacity of the liquid to conduct an electric current. The sensor has two electrodes that come into contact with the liquid to be measured and an alternating signal is applied through the electrodes to avoid polarization. The electric current that flows between the electrodes depends on the concentration of ions in the liquid and the higher the concentration of ions, the greater the conductivity.
Properties
| Technical Features B&C Electronics Conductivity Sensor | |
| Cell constant | K=1 cm-1 (2 to 2,000µS) |
| Body material | Polypropylene |
| 2 electrodes | 316S Stainless Steel |
| Thread | 1” BSP |
| Maximum working temperature | 50ºC |
| Maximum working pressure | 3Bar |
Other products
Housing Ø65 mm | Spindle Ø 6 mm / 8 / 9.52 / 11 / 12 mm Stainless Steel | Operating Temp. 0 – +70 °C | Resolution 2 to 13 bits (4 to 8192 positions) | Max. Load 5 Kg | Max. Frequency 50 kHz | Weight 550 g | Vibration 12 G (10 – 2000 Hz) | Impacts 50 G x 11 ms | Power Supply 5V | LED Life 100k h | IP65/IP66
pH sensor for range 0 to 13pH with 9m cable. Double ring junction.
Produal RTX environment transmitter for temperature, humidity, CO₂, VOCs, and PIR presence. Outputs: 0-10 V, Modbus RTU, BACnet MS/TP, and P/PI control for HVAC and BMS
Conductivity range from 4 to 2,000 mS/cm and TDS (total dissolved solids) from 10ppt to 1,000ppt 4…20mA and Modbus output
Antimony combined reference pH electrode with epoxy body, size 75x12. with 9m cable for the galvanic industry.
Extra Large Laser Reflection Sheet for Structural Customization Range: Extended extreme measurement scalability up to 500 meters
Inclinometer with RS485 output, temperature-compensated, high precision. 1 or 2 axes. Temperature-compensated.
Vibrating wire extensometer for measuring deformations in concrete and steel with high stability and excellent immunity to electromagnetic noise.
Power supply 5-30V | Shaft Ø6-12mm Hollow Stainless Steel | Weight 1680g | Max Load 10kg | Max RPM 6000 | Starting Torque 18 gcm | Bearing Life 1.5×10^9 rev | Impact Resistance 50G | IP65/IP66 | ATEX Certification Ex d II C T6/T5